Adon Complete Air Conditioning and Heating is Anna’s local HVAC company. Most contractors serving this area are driving in from McKinney or further south. We’re not. Our office is right here in Anna. Our owner, Jesse Villarreal, has been serving Collin County homeowners for over 27 years, and our technicians run calls in Anna neighborhoods every single day. Whether you’re in an established neighborhood near downtown, a newer community like Liberty Hills, or getting ready to move into Sherley Farms, we know this city and we’re ready to help.
HVAC Services in Anna, TX
Anna is one of the fastest-growing cities in North Texas, and with thousands of new homes coming online, the demand for reliable heating and cooling service has never been higher. Here’s what we offer Anna homeowners:
AC Repair. Fast diagnosis and repair on all makes and models. We’re already in Anna every day, which means getting to you quickly isn’t a problem.
AC Installation. Whether you’re moving into a new build or replacing an aging system, we size every installation correctly using a proper load calculation. All new installations come with up to a 10-year labor warranty.
HVAC Maintenance. Our Adon Care Club is $12 a month and includes two seasonal tune-ups, priority scheduling, repair discounts, and 24/7 emergency access. For Anna homeowners in new construction, getting on a maintenance plan early is one of the best ways to protect your warranty and catch issues before they become expensive.
Mini-Split Installation. Ductless systems work especially well for garages, home offices, bonus rooms, and additions, all of which are common in Anna’s newer construction neighborhoods.
Heat Pump Installation and Repair. Heat pumps provide year-round heating and cooling from one system. A popular option for Anna’s newer builds where energy efficiency matters.
Indoor Air Quality. New construction homes are built tight for energy efficiency, which means less fresh air circulation. Air filtration systems, UV purifiers, and ventilators help keep the air inside your home clean and healthy. We offer a free “What Are You Breathing?” screening to Anna homeowners.
Air Duct Cleaning. Construction dust and debris in ductwork is a real issue in new builds. Professional duct cleaning after move-in is something we recommend for most Anna homeowners in newer communities.
Air Duct Repair and Sealing. Leaky ducts can cost you 20 to 30 percent of your system’s output. We inspect, repair, and seal ductwork throughout Anna and Collin County.
HVAC Services for Anna’s Growing Neighborhoods
Anna’s population grew roughly 177 percent between 2022 and 2023, making it one of the fastest-growing cities in the country. Sherley Farms, a $1.5 billion master-planned community, broke ground in March 2026 and will bring roughly 3,000 new homes to the city over the next several years. Liberty Hills is adding another 1,800 homes near US-75. That’s thousands of new HVAC systems coming online in a city that’s already one of our busiest service areas.
For homeowners in newer construction, the first few years matter most. Builder-installed systems need to be maintained on schedule to keep warranties valid, and new ductwork should be inspected and cleaned after construction is complete. We’ve helped Anna homeowners navigate all of this, and we know exactly what to look for.
Why Anna Homeowners Choose Adon Complete
- We live here. Our office is at 824 S Central Expressway in Anna. When you call us, you’re calling your neighbor, not a company routing calls from a regional office in Dallas.
- Jesse Villarreal has been doing this for over 27 years. He’s the owner and is actively involved in every aspect of the business. That level of accountability is hard to find at a larger company.
- We’re a Trane Comfort Specialist and Mitsubishi-authorized dealer. Factory-trained installation and the full manufacturer’s warranty on every system we install.
- We service everything. Whatever brand is in your home, we can work on it. We don’t turn jobs away because the equipment isn’t ours.
- The Adon Care Club is $12 a month. Two tune-ups a year, priority scheduling, repair discounts, no diagnostic fees, and 24/7 emergency access.
Frequently Asked Questions
Here are some answers to common questions we get about our Anna HVAC services.
How much does AC repair cost in Anna, TX?
Most AC repairs in Anna run between $150 and $600, depending on the type of repair. Simple fixes like a capacitor replacement are on the lower end. More involved repairs, like a blower motor or evaporator coil, will cost more. We provide a clear estimate before any work begins. Call (903) 482-4900 to schedule a diagnostic visit.
Do you offer emergency HVAC service in Anna?
Yes. We offer 24/7 emergency heating and air conditioning service throughout Anna and Collin County. Since we’re based in Anna, response times are typically faster here than anywhere else we serve.
What HVAC brands do you service in Anna?
We service all makes and models, including Trane, Lennox, Carrier, Daikin, Mitsubishi, Goodman, Rheem, and more. As a Trane Comfort Specialist and Mitsubishi-authorized dealer, we have factory-trained expertise in those brands.
Do you offer HVAC maintenance plans in Anna?
Yes. Our Adon Care Club is $12 a month and includes two seasonal tune-ups, priority scheduling, repair discounts, no diagnostic fees, and 24/7 emergency response. For new construction homeowners especially, staying on a maintenance schedule helps protect your builder warranty.
What areas near Anna do you serve?
We serve all of Anna and the surrounding Collin County communities, including McKinney, Sherman, Melissa, Van Alstyne, and Allen.
Schedule HVAC Service in Anna Today
We’re already in your neighborhood. Call Adon Complete Air Conditioning and Heating at (903) 482-4900 or schedule online.
Recent Jobs and Reviews in Anna, TX
Anna, TX at a glance
Adon Complete Air Conditioning and Heating has completed 10 jobs in Anna, TX in August 2025.
The most recent job was on August 21, 2025.
Adon Complete Air Conditioning and Heating has completed 589 jobs in Anna, TX in the last 12 months. The first job there was in February 2020.
Job Locations
Arrived on site, unit was running at this time and i could hear water churning inside. Upon closer inspection, I found the drain line to be clogged before the p trap and the blower wheel housing is full of water. I showed this to the homeowner and they approved my estimate to address this issue with maintenance. I drained the water from the blower wheel as well as the drain pan. I then cut the drain line to install a blowout valve and proceeded to blowout the drain line both directions and flush with water. I repeated this process about a dozen times until the algae in the coil drain pan was flushed out and the drain line was draining properly. Advised homeowner against turning on the unit as the blower motor was recently wet. Homeowner elected to turn on the unit tonight. Measured 53 degree air coming out of the supply vents. Unit in good working order.
Arrived on site for quality control check. Initially found unit to be keeping up with set point and employees stated all was well and that the system was working great to her knowledge. Started inspection of air handler, found unit to be putting out a cold 50 degrees with a 20 degree temperature split. Inspected wiring connections and found no issues. No blockages of the indoor coil. Noticed slight air leak on some of the duct connections causing a little bit of condensation. I made sure to seal these ducts with a second coat of mastic sealant, in order to ensure maximum efficiency of the system. Tested drain lines and found no issues. Checked refrigerant pressures and found them to be in range. Outdoor unit is leveled properly. Tested float switch to ensure proper operation of safety features and found no issues. Inspected line set and found it to be free of leaks or kinks. Unit is in good working order upon departure.
Demand call for upstairs gas system from 2020, with air filter 20*25*1 not blowing any air. Upon arrival the customer stated they’ve had to replace the control board on the system but didn’t know why it went out. She also mentioned that she hasn’t experienced any power surges or anything that will interfere with her electricity. During my inspection I turned the fan on only and noticed that the fan wasn’t kicking on. I checked voltage and the thermostat is sending signal to the board and the board is distributing the signal to the fan, the fan is also receiving high voltage but it’s not kicking on. I condemned the blower motor and showed my videos to the customer of what was going on. I informed her that without addressing the bad motor I can’t check the rest of the system. She requested an estimate to replace the blower motor because she found out her system isn’t under warranty. At this time the system is off.
We arrived at our clients home for a second opinion regarding the single stage 5 ton unit with 2 zones. We proceeded outside and measured refrigerant pressure while waiting for the homeowner to arrive. We immediately diagnosed a refrigerant restriction and wile the unit was on it triggered a low pressure lockout. We then went inside to inspect the indoor attic unit. We confirmed that the zone board and both damper motors were properly working and allowing airflow to each zone respectfully. We found the indoor evaporator coil to be completely frozen over. The return plenum was extremely dirty with accumulated dust. And the duct work for the zones/system had several kinks/restrictions in them to several parts of the home. We determined the system to have excessive dust which restricted airflow as well as the contributing duct work restriction causing the system to have a leak and be low on refrigerant. The home owner is going to work on contacting TRANE to transfer the equipment under he
We returned to the home today due to the downstairs unit not cooling or working properly after a recent visit by other technicians. We proceeded into the attic and immediately diagnosed a failed transformer. This transformer is not the original one for the unit. In the attic space there were 2 additional transformers that had been replaced already. We looked at the wiring schematics for the air handler and found the existing wiring did not match the schematics. We then proceeded outside and found a contactor that is also near complete failure and may be contributing to or be affected by the failed transformer. We discussed our findings with the homeowners and they informed us that a neighbor across the street had help them with some repairs. An indoor control board, and an indoor blower motor had been acquired by the neighbor. We express how we are hesitant to move forward with repairs given the current state of the equipment, and the potential for underlying issues that are not presen
Upon arrival tenant stated that the unit was not keeping up with the high temps outside. We placed gauges on the system. We were getting low pressures on the gauges. We called the landlord and he approved to add leak seal and 3lbs of refrigerant. We added both and unit was getting 70 degree return air and 50 degree supply. ADD R410A BY THE POUND No warranty no guarantee EASY SEAL DIRECT INJECT 2 - 5 TONS INCLUDES HOSE KIT & 1 CAN 4050-08 OR 4050-11 W/ UV DYE
Upon arrival tenant stated that thermostat was unresponsive on the touch screen on the right side. I checked the thermostat to verify issue. I contacted landlord to present findings of an unresponsive thermostat and provided an estimate for a new thermostat. The landlord elected to go with the new thermostat. All other components were testing within manufacturer specifications. Filter needs to be changed. Tenant was aware of the dirty filter and elected to have to placed back into the unit until a replacement was bought. Unit was cooling upon departure.
Call back for upstairs zone not blowing any air after the duct cleaning was done. During my inspection I found almost every duct to be closed at the damper. I opened up the dampers and the upstairs started receiving cold air. Customer stated that the priority rooms are the children’s rooms and master bedroom, so they had me close a damper that goes to a storage room upstairs to push more air everywhere else. Also mentioned that since they have a single stage zone system we have to adjust the thermostats to be able to keep up with demand the best it can. System is running and cooling upon departure.
1. Visually inspected condenser coil for debris/ dirty. 2. Inspected condenser fan motor. 3. Inspected condenser fan blades. 4. Inspected/ cleaned wiring connections. 5. Tested compressor/ condenser fan motor capacitor. 6. Checked compressor amp draw. 7. Checked condenser fan motor amp draw. 8. Inspected / replaced return filter. 9. Inspected return plenum for debris/ dirty. 10. Inspected evaporator coil. 11. Inspected blower motor/ blower wheel. 12. Checked blower amp draw. 13. Measured temperature differential from supply to return. 20 degrees measured. 14. Inspected drain lines and treated to prevent blockages 15. Rinsed condenser unit to promote heat exchange 16. Replaced and dated filters Homeowner stated he was hearing the attic fan make a noise. Upon inspection, we recorded a video of the attic fan appearing to operate normally without making noise.

