Adon Complete Air Conditioning and Heating is Anna’s local HVAC company. Most contractors serving this area are driving in from McKinney or further south. We’re not. Our office is right here in Anna. Our owner, Jesse Villarreal, has been serving Collin County homeowners for over 27 years, and our technicians run calls in Anna neighborhoods every single day. Whether you’re in an established neighborhood near downtown, a newer community like Liberty Hills, or getting ready to move into Sherley Farms, we know this city and we’re ready to help.
HVAC Services in Anna, TX
Anna is one of the fastest-growing cities in North Texas, and with thousands of new homes coming online, the demand for reliable heating and cooling service has never been higher. Here’s what we offer Anna homeowners:
AC Repair. Fast diagnosis and repair on all makes and models. We’re already in Anna every day, which means getting to you quickly isn’t a problem.
AC Installation. Whether you’re moving into a new build or replacing an aging system, we size every installation correctly using a proper load calculation. All new installations come with up to a 10-year labor warranty.
HVAC Maintenance. Our Adon Care Club is $12 a month and includes two seasonal tune-ups, priority scheduling, repair discounts, and 24/7 emergency access. For Anna homeowners in new construction, getting on a maintenance plan early is one of the best ways to protect your warranty and catch issues before they become expensive.
Mini-Split Installation. Ductless systems work especially well for garages, home offices, bonus rooms, and additions, all of which are common in Anna’s newer construction neighborhoods.
Heat Pump Installation and Repair. Heat pumps provide year-round heating and cooling from one system. A popular option for Anna’s newer builds where energy efficiency matters.
Indoor Air Quality. New construction homes are built tight for energy efficiency, which means less fresh air circulation. Air filtration systems, UV purifiers, and ventilators help keep the air inside your home clean and healthy. We offer a free “What Are You Breathing?” screening to Anna homeowners.
Air Duct Cleaning. Construction dust and debris in ductwork is a real issue in new builds. Professional duct cleaning after move-in is something we recommend for most Anna homeowners in newer communities.
Air Duct Repair and Sealing. Leaky ducts can cost you 20 to 30 percent of your system’s output. We inspect, repair, and seal ductwork throughout Anna and Collin County.
HVAC Services for Anna’s Growing Neighborhoods
Anna’s population grew roughly 177 percent between 2022 and 2023, making it one of the fastest-growing cities in the country. Sherley Farms, a $1.5 billion master-planned community, broke ground in March 2026 and will bring roughly 3,000 new homes to the city over the next several years. Liberty Hills is adding another 1,800 homes near US-75. That’s thousands of new HVAC systems coming online in a city that’s already one of our busiest service areas.
For homeowners in newer construction, the first few years matter most. Builder-installed systems need to be maintained on schedule to keep warranties valid, and new ductwork should be inspected and cleaned after construction is complete. We’ve helped Anna homeowners navigate all of this, and we know exactly what to look for.
Why Anna Homeowners Choose Adon Complete
- We live here. Our office is at 824 S Central Expressway in Anna. When you call us, you’re calling your neighbor, not a company routing calls from a regional office in Dallas.
- Jesse Villarreal has been doing this for over 27 years. He’s the owner and is actively involved in every aspect of the business. That level of accountability is hard to find at a larger company.
- We’re a Trane Comfort Specialist and Mitsubishi-authorized dealer. Factory-trained installation and the full manufacturer’s warranty on every system we install.
- We service everything. Whatever brand is in your home, we can work on it. We don’t turn jobs away because the equipment isn’t ours.
- The Adon Care Club is $12 a month. Two tune-ups a year, priority scheduling, repair discounts, no diagnostic fees, and 24/7 emergency access.
Frequently Asked Questions
Here are some answers to common questions we get about our Anna HVAC services.
How much does AC repair cost in Anna, TX?
Most AC repairs in Anna run between $150 and $600, depending on the type of repair. Simple fixes like a capacitor replacement are on the lower end. More involved repairs, like a blower motor or evaporator coil, will cost more. We provide a clear estimate before any work begins. Call (903) 482-4900 to schedule a diagnostic visit.
Do you offer emergency HVAC service in Anna?
Yes. We offer 24/7 emergency heating and air conditioning service throughout Anna and Collin County. Since we’re based in Anna, response times are typically faster here than anywhere else we serve.
What HVAC brands do you service in Anna?
We service all makes and models, including Trane, Lennox, Carrier, Daikin, Mitsubishi, Goodman, Rheem, and more. As a Trane Comfort Specialist and Mitsubishi-authorized dealer, we have factory-trained expertise in those brands.
Do you offer HVAC maintenance plans in Anna?
Yes. Our Adon Care Club is $12 a month and includes two seasonal tune-ups, priority scheduling, repair discounts, no diagnostic fees, and 24/7 emergency response. For new construction homeowners especially, staying on a maintenance schedule helps protect your builder warranty.
What areas near Anna do you serve?
We serve all of Anna and the surrounding Collin County communities, including McKinney, Sherman, Melissa, Van Alstyne, and Allen.
Schedule HVAC Service in Anna Today
We’re already in your neighborhood. Call Adon Complete Air Conditioning and Heating at (903) 482-4900 or schedule online.
Recent Jobs and Reviews in Anna, TX
Anna, TX at a glance
Adon Complete Air Conditioning and Heating has completed 10 jobs in Anna, TX between February 2026 and March 2026.
The most recent job was on March 2, 2026.
Adon Complete Air Conditioning and Heating has completed 588 jobs in Anna, TX in the last 12 months. The first job there was in February 2020.
Job Locations
I performed a single cooling maintenance on a 6 month old gas system. I checked amps, capacitor, filter, electrical, drains, cleanliness, and safeties. The system is performing well. I offered to install a surge protector to protect his investment, but the customer declined.
I performed a single cooling maintenance on a 2021 heat pump system. I checked amps, capacitor, filter, electrical, cleanliness, drains, and safeties. I observed that growth is starting to form in the air handler, and the system did not have surge protection. I proceeded to offer options for these items. Customer approved the installation of a surge protector. I tested the system afterwards to ensure it was cooling.
1. Rinsed condenser with water to promote heat exchange and reduce stress on system 2. Visually inspected condenser coil for debris/ dirty. 3. Inspected condenser fan motor. 4. Inspected condenser fan blades. 5. Inspected/ cleaned wiring connections. 6. Tested compressor/ condenser fan motor capacitor. 7. Checked compressor amp draw. 8. Checked condenser fan motor amp draw. 9. Inspected / replaced return filter. 10. Inspected return plenum for debris/ dirty. 11. Inspected evaporator coil. 12. Inspected blower motor/ blower wheel. 13. Checked blower amp draw. 14. Measured temperature differential from supply to return. 20 degrees measured. 15. Inspected drain lines and treated to prevent blockages Upon inspection of the outdoor unit, I found that the insulation on one of the copper line sets was falling. Measured both outdoor capacitors are testing within manufacture spec, however both are testing very low or right on the edge and 4 years old. Both of these capacitors are liable to fa
1. Rinsed condenser with water to promote heat exchange and reduce stress on system 2. Visually inspected condenser coil for debris/ dirty. 3. Inspected condenser fan motor. 4. Inspected condenser fan blades. 5. Inspected/ cleaned wiring connections. 6. Tested compressor/ condenser fan motor capacitor. 7. Checked compressor amp draw. 8. Checked condenser fan motor amp draw. 9. Inspected / replaced return filter. 10. Inspected return plenum for debris/ dirty. 11. Inspected evaporator coil. 12. Inspected blower motor/ blower wheel. 13. Checked blower amp draw. 14. Measured temperature differential from supply to return. 20 degrees measured. 15. Inspected drain lines and treated to prevent blockages Immediately noticed that the outdoor unit had taken some hail damaged during the storms. Found capacitor was testing within range but a bit low and over 5years showing signs of rust. Capacitor is liable to fail at this point in its life as it is past the expected life span. Also noticed oil
1. Rinsed condenser with water to promote heat exchange and reduce stress on system 2. Visually inspected condenser coil for debris/ dirty. 3. Inspected condenser fan motor. 4. Inspected condenser fan blades. 5. Inspected/ cleaned wiring connections. 6. Tested compressor/ condenser fan motor capacitor. 7. Checked compressor amp draw. 8. Checked condenser fan motor amp draw. 9. Inspected / replaced return filter. 10. Inspected return plenum for debris/ dirty. 11. Inspected evaporator coil. 12. Inspected blower motor/ blower wheel. 13. Checked blower amp draw. 14. Measured temperature differential from supply to return. 20 degrees measured. 15. Inspected drain lines and treated to prevent blockages Upon inspection of the upstairs air handler, I found no float switch on the primary drain line. Recommend addition of float switch to avoid water coming through the ceiling Should the drain line become clogged. Upon testing, I found high start amps on the outdoor unit. This is indicative of
The capacitor on the upstairs unit was bad. Was not turning on the compressor. Manufacturer of the capacitor is Carrier. The customer still has warranty on the capacitor.. After completing diagnostics on your upstairs HVAC system, we found that the evaporator coil’s TXV (Thermal Expansion Valve) is not regulating refrigerant properly. The valve is fluctuating, which is causing inconsistent suction and head pressures. Because of this, the system is not operating at peak efficiency and performance. The good news is that your evaporator coil is still under manufacturer warranty with Carrier. Rather than replacing only the TXV, we are recommending a full evaporator coil replacement. The new coil will come with a factory-installed TXV, ensuring proper refrigerant metering and restoring system performance. Replacing the complete coil assembly is the most reliable and warranty-compliant solution, and it helps protect the compressor from long-term damage caused by improper refrigerant f
Returned to install u/v light
I performed a single cooling maintenance on a 2023 heat pump system. I thoroughly evaluated the operation, drains, electrical components, cleanliness, and safeties of the system. The customer brought to my attention an allergen concern. I informed the customer about how u/v lights degrade over time and other products that can be used to address this. Customer elected to replace the reme halo bulb during the time of service.
Arrived on site, found upstairs outdoor unit in hard lockout. Reset power and compressor and both motors fired on without issue. Check temperature split and was measuring only about 10°. Checked refrigerant pressures and found them to be low. Proceeded to the indoor evaporator coil and leak tested electronically. I then found a leak in the back loops of the evaporator coil video included. Shut off unit at the breaker to prevent damage to the compressor. Advised homeowner that they were covered under parts and labor warranty. The only thing they would be on the hook for is the filter dryer and any refrigerant we would need to put in the system. I had to quote the full amount of refrigerant that the unit holds in case the refrigerant does all leak out. However, at this point the leak does not appear to be large and the system has a decent amount of refrigerant so I do not think we will need the full amount. Advised homeowner we would call the supply house first thing in the morning and u
Preformed heating maintenance on a 5 ton Trane heat pump 2025. I tested all electrical components on the inside air handler. All tested within manufacturer specifications. Client did not have filter for us to changed at this time, filter size 20x25x4 Aprilaire 213. I rocoeed3d outside and tested all electrical components on the outside unit and cleanliness. Unit was very clean and electrical components all tested within manufacturer specifications. Temp being supplied to the venue is 107 degrees and 68 being returned to the unit. Unit was heating upon departure.

