Adon Complete Air Conditioning and Heating is Anna’s local HVAC company. Most contractors serving this area are driving in from McKinney or further south. We’re not. Our office is right here in Anna. Our owner, Jesse Villarreal, has been serving Collin County homeowners for over 27 years, and our technicians run calls in Anna neighborhoods every single day. Whether you’re in an established neighborhood near downtown, a newer community like Liberty Hills, or getting ready to move into Sherley Farms, we know this city and we’re ready to help.
HVAC Services in Anna, TX
Anna is one of the fastest-growing cities in North Texas, and with thousands of new homes coming online, the demand for reliable heating and cooling service has never been higher. Here’s what we offer Anna homeowners:
AC Repair. Fast diagnosis and repair on all makes and models. We’re already in Anna every day, which means getting to you quickly isn’t a problem.
AC Installation. Whether you’re moving into a new build or replacing an aging system, we size every installation correctly using a proper load calculation. All new installations come with up to a 10-year labor warranty.
HVAC Maintenance. Our Adon Care Club is $12 a month and includes two seasonal tune-ups, priority scheduling, repair discounts, and 24/7 emergency access. For Anna homeowners in new construction, getting on a maintenance plan early is one of the best ways to protect your warranty and catch issues before they become expensive.
Mini-Split Installation. Ductless systems work especially well for garages, home offices, bonus rooms, and additions, all of which are common in Anna’s newer construction neighborhoods.
Heat Pump Installation and Repair. Heat pumps provide year-round heating and cooling from one system. A popular option for Anna’s newer builds where energy efficiency matters.
Indoor Air Quality. New construction homes are built tight for energy efficiency, which means less fresh air circulation. Air filtration systems, UV purifiers, and ventilators help keep the air inside your home clean and healthy. We offer a free “What Are You Breathing?” screening to Anna homeowners.
Air Duct Cleaning. Construction dust and debris in ductwork is a real issue in new builds. Professional duct cleaning after move-in is something we recommend for most Anna homeowners in newer communities.
Air Duct Repair and Sealing. Leaky ducts can cost you 20 to 30 percent of your system’s output. We inspect, repair, and seal ductwork throughout Anna and Collin County.
HVAC Services for Anna’s Growing Neighborhoods
Anna’s population grew roughly 177 percent between 2022 and 2023, making it one of the fastest-growing cities in the country. Sherley Farms, a $1.5 billion master-planned community, broke ground in March 2026 and will bring roughly 3,000 new homes to the city over the next several years. Liberty Hills is adding another 1,800 homes near US-75. That’s thousands of new HVAC systems coming online in a city that’s already one of our busiest service areas.
For homeowners in newer construction, the first few years matter most. Builder-installed systems need to be maintained on schedule to keep warranties valid, and new ductwork should be inspected and cleaned after construction is complete. We’ve helped Anna homeowners navigate all of this, and we know exactly what to look for.
Why Anna Homeowners Choose Adon Complete
- We live here. Our office is at 824 S Central Expressway in Anna. When you call us, you’re calling your neighbor, not a company routing calls from a regional office in Dallas.
- Jesse Villarreal has been doing this for over 27 years. He’s the owner and is actively involved in every aspect of the business. That level of accountability is hard to find at a larger company.
- We’re a Trane Comfort Specialist and Mitsubishi-authorized dealer. Factory-trained installation and the full manufacturer’s warranty on every system we install.
- We service everything. Whatever brand is in your home, we can work on it. We don’t turn jobs away because the equipment isn’t ours.
- The Adon Care Club is $12 a month. Two tune-ups a year, priority scheduling, repair discounts, no diagnostic fees, and 24/7 emergency access.
Frequently Asked Questions
Here are some answers to common questions we get about our Anna HVAC services.
How much does AC repair cost in Anna, TX?
Most AC repairs in Anna run between $150 and $600, depending on the type of repair. Simple fixes like a capacitor replacement are on the lower end. More involved repairs, like a blower motor or evaporator coil, will cost more. We provide a clear estimate before any work begins. Call (903) 482-4900 to schedule a diagnostic visit.
Do you offer emergency HVAC service in Anna?
Yes. We offer 24/7 emergency heating and air conditioning service throughout Anna and Collin County. Since we’re based in Anna, response times are typically faster here than anywhere else we serve.
What HVAC brands do you service in Anna?
We service all makes and models, including Trane, Lennox, Carrier, Daikin, Mitsubishi, Goodman, Rheem, and more. As a Trane Comfort Specialist and Mitsubishi-authorized dealer, we have factory-trained expertise in those brands.
Do you offer HVAC maintenance plans in Anna?
Yes. Our Adon Care Club is $12 a month and includes two seasonal tune-ups, priority scheduling, repair discounts, no diagnostic fees, and 24/7 emergency response. For new construction homeowners especially, staying on a maintenance schedule helps protect your builder warranty.
What areas near Anna do you serve?
We serve all of Anna and the surrounding Collin County communities, including McKinney, Sherman, Melissa, Van Alstyne, and Allen.
Schedule HVAC Service in Anna Today
We’re already in your neighborhood. Call Adon Complete Air Conditioning and Heating at (903) 482-4900 or schedule online.
Recent Jobs and Reviews in Anna, TX
Anna, TX at a glance
Adon Complete Air Conditioning and Heating has completed 10 jobs in Anna, TX in May 2025.
The most recent job was on May 19, 2025.
Adon Complete Air Conditioning and Heating has completed 589 jobs in Anna, TX in the last 12 months. The first job there was in February 2020.
Job Locations
Performed a 1 system spring maintenance ( heat pump). Tasks performed. 1. Visually inspected condenser coil for debris/ dirty. 2. Inspected condenser fan motor. 3. Inspected condenser fan blades. 4. Inspected/ cleaned wiring connections. 5. Tested compressor/ condenser fan motor capacitor. 6. Checked refrigerant pressures. 7. Checked compressor amp draw. 8. Checked condenser fan motor amp draw. 9. Inspected / replaced return filter,,,clean effects filter is very dirty,, highly recommended to clean it. 10. Inspected return plenum for debris/ dirty,,is very dusty,, highly recommended to clean it for better performance/ indoor air quality. 11. Inspected evaporator coil. 12. Inspected blower motor/ blower wheel 13. Checked blower amp draw. 14. Measured temperature differential . 15. Inspected drain lines. 16. Washed condenser unit. Will send estimates form recommendations,, unit is working properly at this time. Homeowner mentioned that the unit switched to heat on its own couple of times
Preformed Cooling System maintenance. Tested start and run amps for the compressor and condenser fan. Found that the ohms on the contactor tested high at 19 ohms. Offered estimate to change the contactor, along with a hard start kit for the compressor. Went inside and found that the filter was dirty and the blower wheel was dirty, also found the ptrap to not be insulated causing condensation to build up and drip water in the closet space. Our client did give a replacement filter for us to change today. We did use Total C drain cleaner to help clear the drain line and also washed the outdoor coil as part of today’s maintenance. We Offered estimate for both a blower wheel cleaning and a blow out valve with ptrap insulation. The unit is old and recommend filter to be changed monthly to prevent any further issues. System cooling on departure.
We first got here the compressor was in a thermo overload, we cooled down the compressor. We then proceeded to check to see if there was dirty filters in a different part of the house. No other filters are present. We checked pressures on the system and found that the compressor was not pumping refrigerant through the system. We checked for continuity on all legs of the compressor, they tested good. We spoke with tech support William to get better understanding on what may have caused the issue. After speaking with him we came to the conclusion that the compressor failed due to possible debris or liquid in the suction line. Spoke Paola she will begin the process of ordering another warranty compressor.
Scheduled for Monday at 9am. Refrigerant line is vibrating in the wall. From what I can tell, it’s caused by poor airflow. The evaporator coil is dirty, the blower is dirty, the blower doesn’t appear to be revving up, and the condenser fan motor is shot. Customer wants price on system replacment
Found the system not building head pressure and a none existent subcool. The suction pressure was reading good with a good super heat. This indicated that the TXV is over feeding the evaporator coil. The system only had a 15 degree temperature split. I relocated the bulb to outside the unit. This made the sub cooling go from 1 to 3. The system is suppose to have a 5 degree sub cool in 90 degree weather. We provided pricing for a replacement TXV and a 3 1/2 heat pump complete. Jesse approved crediting back 800.00 on a complete system. The financing per month cost on the equipment is around 174.00. Customer wants to think about it over the weekend before deciding.
Customer complained that compressor was very loud. Upon inspection I found the unit to be low on refrigerant and proceeded to perform a leak search. I got intermittent hits on the leak detector with a few big spikes indicating that the leak was.
Returned to unit not cooling. Immediately found outside unit making a loud noise and identifying the compressor to not be pumping properly. Rechecked and tested the outdoor compressor and it is compromised. I proceeded indoors to double check the indoor unit. The unit did have evidence of a leak. I am. It sure if the TXV became restricted and damaged the compressor or if the compressor overheated and forced a leak at the bolt on compressor. We are scheduled to complete warranty repair tomorrow.
Upon arrival, I found that the p trap was split causing water to leak until no water was left in it. I presented my findings to the home owner and they approved the replacement of the ptrap. I flushed the ptrap and gave a complimentary drain treatment. The system is no longer leaking. The Customer stated they had preventative maintenance done by another company, when I asked if they would like me to test and check the unit.
Customer stated her friend came over and determined there was a leak but did not have those tools to find the leak. Measured a 15° split. Inspected and found leak at evaporator. Quoted coil replacement.
Upon arrival, I found that the compressor was not pumping refrigerant through the system. This would make it appear that the outside unit was working. I opened the outdoor unit and found that the capacitor was bloated out. This is a sign that the capacitor has failed. I provided options to replace the capacitor and the customer chose to go with the turbo200 capacitor. After installation, I performed a series of tests on the system. I noticed some other things that I brought to the attention of the customer. I provided options for an emergency pan, clearing the primary drain, ss1 float switch, blow out valve, and a blowout valve. The emergency pan has rust penetration. This means there is a risk that the pan may leak onto the attic floor in the near future. The float switch is designed to shut the system down if a clog occurs. The blow out valve turns the drain into a self serve. If it becomes clogged, this allows anyone to connect and blow it out. The compressor is currently starting a

