Frisco has grown faster than almost any city in America over the past two decades, and the homes here reflect it. Larger floor plans, multi-zone systems, high-efficiency equipment, and newer construction in neighborhoods like The Fields, Phillips Creek Ranch, and Viridian. Keeping all of it running well takes an HVAC company that knows what it’s doing. Adon Complete Air Conditioning and Heating has been running calls for HVAC service in Frisco for years from our home base in Anna, just up the Dallas North Tollway corridor. We’re a Trane Comfort Specialist and Mitsubishi-authorized dealer, and we’re available 24 hours a day, 7 days a week for emergencies.
What We Do for Frisco Homeowners
AC Repair. We diagnose and repair all makes and models. Frisco’s newer construction often means multi-zone systems and communicating equipment — our technicians know how to work on all of it.
AC Installation. When it’s time to replace, we size every system correctly using a proper load calculation. That matters especially in Frisco’s larger homes where an improperly sized system will short-cycle and leave rooms uncomfortable. All new installations come with up to a 10-year labor warranty.
HVAC Maintenance. Our Adon Care Club is $12 a month and includes two seasonal tune-ups, priority scheduling, repair discounts, and 24/7 emergency access. For Frisco homeowners with high-end systems, staying on a maintenance schedule is one of the best ways to protect your investment.
Mini-Split Installation. Garages, home offices, casitas, and bonus spaces are common in Frisco’s larger homes. Mini-splits handle these spaces cleanly without touching your central system.
Heat Pump Installation and Repair. Heat pumps provide both heating and cooling from one system and work well in North Texas’s climate. A practical choice for Frisco homeowners upgrading to a more efficient setup.
Indoor Air Quality. Air filtration systems, UV purifiers, humidifiers, dehumidifiers, and a free “What Are You Breathing?” screening. Frisco’s tight construction means less natural ventilation, making air quality systems more important than in older homes.
Air Duct Cleaning. Even newer ductwork accumulates contaminants over time. Professional duct cleaning improves air quality and keeps your system running efficiently throughout the home.
Air Duct Repair and Sealing. Leaky ducts can cost you 20 to 30 percent of your system’s output. In a larger Frisco home, that adds up fast. We inspect, repair, and seal ductwork throughout the area.
Why Frisco Homeowners Choose Adon Complete
Frisco has no shortage of HVAC companies competing for business. Here’s why our customers keep calling us back.
We know multi-zone and communicating systems. The job notes from our Frisco calls show what we actually work on here – damper adjustments, multi-system diagnostics, communicating Trane equipment, humidity management in two-story homes. This isn’t routine work, and we handle it well.
Jesse Villarreal has over 27 years of experience. He’s the owner and is directly involved in how the business operates. When something goes wrong, you’re dealing with a company where the owner’s reputation is on the line.
We’re a Trane Comfort Specialist and Mitsubishi-authorized dealer. Factory-trained on the brands most common in Frisco’s newer construction. Full manufacturer warranty on every system we install.
The Adon Care Club is $12 a month. Two tune-ups a year, priority scheduling, repair discounts, no diagnostic fees, and 24/7 emergency access. Straightforward and affordable.
Serving Frisco and Surrounding Collin County Communities
We serve all of Frisco, including The Fields, Phillips Creek Ranch, Viridian, Stonebriar, and the established neighborhoods along Preston Road and the Dallas North Tollway. We also serve the surrounding communities of Allen, McKinney, Anna, Melissa, and Sherman.
Frequently Asked Questions
Here are some common questions we get about our HVAC services in Frisco.
How much does AC repair cost in Frisco, TX?
Most AC repairs in Frisco run between $150 and $600 depending on the type of repair. Frisco’s newer homes often have multi-zone systems and higher-end equipment, which can affect parts costs. We provide a clear estimate before any work begins. Call (903) 482-4900 to schedule a diagnostic visit.
Do you service multi-zone systems in Frisco?
Yes. Multi-zone systems and communicating HVAC equipment are common in Frisco’s larger homes, and our technicians work on them regularly. We service all makes and models, including Trane, Lennox, Carrier, Daikin, Mitsubishi, and more.
Do you offer HVAC maintenance plans in Frisco?
Yes. Our Adon Care Club is $12 a month and includes two seasonal tune-ups, priority scheduling, repair discounts, no diagnostic fees, and 24/7 emergency response. Preventive maintenance is especially important for the multi-system setups common in Frisco’s larger homes.
Do you offer emergency HVAC service in Frisco?
Yes. We offer 24/7 emergency heating and air conditioning service throughout Frisco. When you call after hours, you reach a real person who can get a technician to your home fast.
What areas near Frisco do you serve?
We serve all of Frisco and the surrounding communities including Allen, McKinney, Anna, Melissa, and Sherman.
Ready to Get Your System Serviced?
Call Adon Complete Air Conditioning and Heating at (903) 482-4900 or schedule online for HVAC services in Frisco. We handle everything from routine maintenance to emergency repairs throughout Frisco and Collin County.
Recent Jobs and Reviews in Frisco, TX
Frisco, TX at a glance
Adon Complete Air Conditioning and Heating has completed 10 jobs in Frisco, TX between May 2025 and June 2025.
The most recent job was on June 17, 2025.
Adon Complete Air Conditioning and Heating has completed 51 jobs in Frisco, TX in the last 12 months. The first job there was in March 2020.
Job Locations
Did a walk-through with the customer and Jose. Verified the locations where the customer wants his wall mount unit to be installed. Jose is just trying to get an ETA from Mitsubishi when equipment will be arriving to schedule install.
Preformed Quality Control check. Client did mention that the bedrooms upstairs were not getting as cold as the media room and play room. We addressed the issue by adjusting the ducts to allow adequate airflow to each of those rooms. Refrigerant levels are within operational standards. Client mentioned filters may need to be changed. Advised filters do need to be changed but client didn’t have any replacements. Unit cooling on departure. Filter 20x25x4 and 16x20x4
Preformed cooling maintenance on four systems. Tested all electrical components for all four systems. They all tested within manufacture specifications. Washed outside coils for all four units. We replaced all four filters for the client. Discussed benefits of air purification. Offered customer blower wheel cleaning for main upstairs, also offered customer to add four surge protectors one for each unit. Customer would like estimates for everything to be sent over to the email on file.
Arrived at our clients home for the upstairs unit not cooling properly. We proceeded inside and verified the thermostat was on and calling for cooling. The indoor attic unit was also on and sending the correct power outside. On the outdoor unit we immediately found it not coming on a making a buzzing noise. The outdoor disconnect plug is broken inside the disconnect box and we shut off power at the indoor breaker panel. We then diagnosed a completely dead capacitor. The buzzing noise was coming from the contactor that is almost near failure also. It is reading 18.6 out of 20ohms. We further tested to ensure the fan motor and compressor motor were not compromised and would start up with components repairs. We also found the outdoor coils extremely dirty. This would directly contribute to the unit not being able to keep up and adding stress to the components until they failed. I was able to speak to Mr Chris on the phone and we discussed the most minimum repair he could do for the u
Homeowner stated that the upstairs unit is not cooling,, that we were here couple of weeks ago for the maintenance. Found a bad capacitor (40/5) ,,,was replaced today , homeowner has parts and labor warranty. Unit was tested on cooling mode, unit draws 48 amp at start up,, highly recommended a hard start kit. We measured temperature differential, had 21 degrees split differential,, found no more issues/ concerns at this time.
Performed a 2 system spring maintenance ( gas). Tasks performed. 1. Visually inspected condenser coil for debris/ dirty,,noticed both units don’t have surge protection. 2. Inspected condenser fan motor. 3. Inspected condenser fan blades. 4. Inspected/ cleaned wiring connections. 5. Tested compressor/ condenser fan motor capacitor,,, downstairs unit has a hard start kit due to high starting amps,,recommended to install one o the upstairs unit as well to extend the compressor’s life. 6. Checked refrigerant pressures. 7. Checked compressor amp draw. 8. Checked condenser fan motor amp draw. 9. Inspected / replaced return filter. 10. Inspected return plenum for debris/ dirty. 11. Inspected evaporator coil. 12. Inspected blower motor/ blower wheel. 13. Checked blower amp draw. 14. Measured temperature differential . 15. Inspected drain lines. 16. Washed condenser unit. Upstairs unit temperature differential is right on the edge ( 17 degrees split differential), homeowner will monitor the u
Homeowner stated that the upstairs unit is not cooling, that h the indoor unit is blowing hot air. Found the condenser unit very low on refrigerant, had 40 psig on the suction/ discharge line,, proceeded to do a leak search, unfortunately we couldn’t pinpoint the leak at this time due to extremely low pressure but we nota significant amount of oil inside the emergency drain pan , highly believe there is a refrigerant leak at the evaporator coil,,, needs to be replaced.
I arrived at our clients home for the downstairs unit not cooling properly. I proceeded into the attic and identified the correct unit and found a blown fuse in the system. I proceeded outside and tested the electrical components. Everything tested within range today. I then proceeded to test the low voltage wires and found that the wires sending power from the attic to the outdoor equipment had been compromised somewhere in the wire run. The client is aware of an ongoing rodent issue and there was evidence of rodents in the attic as well as existing traps. I further tested the existing wires to ensure there was a connection that could be made that was not compromised. I made the necessary wire changes to the indoor and outdoor equipment and also replaced the fuse in the attic. I then turned the unit on and ensured it was cooling properly. It had a 20° drop and the filter is in good condition. If the wire is further compromised and no spare wires are available to send power, new th
1. Visually inspected condenser coil for debris/ dirty. 2. Inspected condenser fan motor. 3. Inspected condenser fan blades. 4. Inspected/ cleaned wiring connections. Found concerning burn marks on the older downstairs unit’s disconnect wires as well as melted plastic in the disconnect. 5. Tested compressor/ condenser fan motor capacitor. Compressor capacitor is testing just blow range but amps are within range on the older downstairs unit 6. Checked compressor amp draw. 7. Checked condenser fan motor amp draw. 8. Inspected / replaced return filter. 9. Inspected return plenum for debris/ dirty. Returns are accumulating a good amount of dust 10. Inspected evaporator coil. 11. Inspected blower motor/ blower wheel. 12. Checked blower amp draw. 13. Measured temperature differential from supply to return. 20 degrees measured. 14. Inspected drain lines 15. Washed condenser unit to promote heat exchange Also noticed the older unit was missing insulation on the suction line. this will reduc
This estimate is only for system replacement. Only will be replaced is the outside unit. Gas furnace evaporator and coil. Will be using existing thermostat concrete pad, whip disconnect. Supply box return box filtration. If there’s any additional work needs to be done is not included in this estimated price. If there’s a city permit is required. Customer is responsible for the fees. This is the cash price only check or cash only. Customers responsible to provide minimum 10 referrals, service or equipment replacements. ******** CASH Price **********

