Twenty-five service calls in Prosper between January and September 2026. That’s not a number we’re making up – it comes from our own technicians’ job logs. Adon Complete Air Conditioning and Heating has been running AC repair and HVAC service calls in Prosper, TX for years, and the homes here are exactly what our technicians are built for. Large floor plans, multiple systems, a mix of 2016-era Trane and Lennox units hitting the ten-year mark alongside brand-new 2023 and 2025 installs. We know what’s in these homes because we’ve worked on them. We’re a Trane Comfort Specialist and Mitsubishi-authorized dealer, and we’re available 24 hours a day, 7 days a week.
What We See on Prosper Service Calls
Prosper’s homes tend to run two, three, or four HVAC systems. Many of the 2016 builds are reaching the point where capacitors, blower motors, and contactors are starting to wear. The newer 2023 and 2025 installs are still early in their life but need proper maintenance to protect the manufacturer’s warranty. Here’s a snapshot of what our technicians handle in Prosper regularly:
Four-system maintenance on a home with three 2016 Trane units and one 2025 Lennox. Two-system maintenance on back-to-back 2020 and 2023 Trane gas systems. Air balance diagnostics for a master bedroom hotspot. Mold inspection near an evaporator coil drain. Surge protector installations on outdoor disconnects. Blower motor replacements. Aprilaire filter upgrades from standard four-inch box filters. These are not unusual calls for Prosper. They’re typical.
Services We Offer in Prosper
AC Repair. All makes and models. From a failed capacitor on a 2016 unit to a blower motor replacement on a newer system, we diagnose it and fix it right.
AC and Heating Installation. Whether you’re replacing one aging unit or upgrading an entire multi-system setup, we size everything using a proper load calculation and back every installation with up to a 10-year labor warranty.
HVAC Maintenance. Our Adon Care Club is $12 a month. Two seasonal tune-ups, priority scheduling, repair discounts, no diagnostic fees, and 24/7 emergency access. For Prosper homeowners with multiple systems, staying on a maintenance schedule is one of the smartest ways to catch problems early.
Mini-Split Installation. In-law suites, bonus rooms, and detached garages are common in Prosper’s larger homes. Our technicians have installed ductless systems throughout Prosper as a practical solution for spaces the central system doesn’t reach well.
Heat Pump Installation and Repair. Heat pumps are turning up more frequently in Prosper’s newer builds. We install and service them alongside traditional gas systems throughout the area.
Indoor Air Quality. Our technicians have recommended UV light installations, Aprilaire filter upgrades, and duct cleaning on multiple Prosper service calls this year. If your systems are aging or you’ve had moisture or air quality concerns, we offer a free “What Are You Breathing?” screening.
Air Duct Cleaning. Several of our Prosper job notes this year flag ductwork and blower wheels that are overdue for cleaning on 2016-era systems. Professional duct cleaning improves air quality and helps the system run more efficiently.
Air Duct Repair and Sealing. Leaky ducts account for 20 to 30 percent of system output loss. We’ve found and fixed duct issues on Prosper homes that were causing uneven cooling between floors. We inspect, repair, and seal ductwork throughout the area.
About Adon Complete
Owner Jesse Villarreal has been in HVAC for over 27 years. We’re based in Anna and run calls throughout Collin County every day. As a Trane Comfort Specialist and Mitsubishi-authorized dealer we have factory-trained technicians on the brands most common in Prosper’s homes. We service everything, not just what we sell, and we give you a straight answer about what the system needs before we do any work.
Prosper and Surrounding Collin County Communities
We serve all of Prosper and the surrounding communities, including Celina, Frisco, McKinney, Allen, and Anna, throughout Collin County.
Common Questions From Prosper Homeowners
My home has three or four HVAC systems. Can you handle all of them?
Yes. Multi-system homes are standard for us in Prosper. We’ve done four-system maintenance visits, diagnosed air balance issues between floors, and replaced components on multiple units in a single visit. One call covers everything.
My 2016 Trane units are starting to have issues. Should I repair or replace?
That depends on what’s failing and the overall condition of the system. A capacitor or contactor replacement on a 2016 unit is usually worth doing. A compressor failure on the same system is a different conversation. We give you an honest assessment of what it would cost to repair versus what a replacement would run, and we let you make the call. Call (903) 482-4900 to schedule a diagnostic visit.
How often should multi-system homes in Prosper get maintenance?
Twice a year minimum. Spring before cooling season and fall before heating season. With multiple systems running, catching a failing capacitor or a dirty blower wheel early prevents the kind of emergency repairs that happen at the worst possible time. Our Adon Care Club at $12 a month covers all of your systems on those two visits.
Do you install surge protectors for HVAC systems in Prosper?
Yes. We recommend surge protectors on outdoor disconnects for Prosper homes, especially homes that took lightning-related damage or had a disconnect issue. We’ve installed them on multiple Prosper properties this year. A surge protector is a straightforward way to protect equipment that’s expensive to replace.
What areas near Prosper do you serve?
We serve all of Prosper and the surrounding Collin County communities, including Celina, Frisco, McKinney, Allen, and Anna.
Schedule AC Repair or HVAC Service in Prosper
Whether you need a repair, a maintenance visit on multiple systems, or just want to get a set of eyes on aging equipment, call our team at Adon Complete Air Conditioning and Heating at (903) 482-4900 or schedule online. We know Prosper, and we’re ready to help.
Recent Jobs and Reviews in Prosper, TX
Prosper, TX at a glance
Adon Complete Air Conditioning and Heating has completed 10 jobs in Prosper, TX between March 2025 and May 2025.
The most recent job was on May 22, 2025.
Adon Complete Air Conditioning and Heating has completed 30 jobs in Prosper, TX in the last 12 months. The first job there was in March 2020.
Job Locations
Performed a 1 system spring maintenance ( gas). Tasks performed. 1. Visually inspected condenser coil for debris/ dirty. 2. Inspected condenser fan motor. 3. Inspected condenser fan blades. 4. Inspected/ cleaned wiring connections. 5. Tested compressor/ condenser fan motor capacitor,,,highly recommended a hard start kit to extend the life on the compressor and release some stress at start up. 6. Checked refrigerant pressures. 7. Checked compressor amp draw. 8. Checked condenser fan motor amp draw. 9. Inspected / replaced return filter. 10. Inspected return plenum for debris/ dirty. 11. Inspected evaporator coil. 12. Inspected blower motor/ blower wheel. 13. Checked blower amp draw. 14. Measured temperature differential . 15. Inspected drain lines. 16. Washed condenser unit. Found no issues/ concerns at this time, unit is cooling properly. Will send estimate for recommendation.
Customer spoke about past things done involving the hvac equipment. The blower speed has been slowed down, and refrigerant added. I confirmed that the refrigerant is correctly charged. I investigated reasoning behind the E2 error code and the high-ish humidity. The E2 code on the Aprilaire fresh air intake is caused by either restricted airflow/dirty filter, failed sensor, or high air temperature. I assume it’s the later that is causing the error code. The system is a single stage gas system. The thermostat is in range to be getting tricked by the supply air. I recommend adding scoops to the bedroom supply vents to advert the air. If the issue persists, we will either need to replace the thermostat with a 824 Trane w/ sensors or add a dehumidifier. I am putting in a service estimate request for pricing.
Returned to install 2 carrier warranty capacitors. I tested both systems after installation and they are performing well. The old capacitor on the main unit was reading 8mfd/45mfd on the compressor side. This was sure to fail soon.
I arrived at our clients home for the upstairs unit not cooling properly. Our client controls the thermostat remotely and after turning it on I was able to begin testing and inspecting the equipment. I verified the indoor attic unit to come on and send proper signal outside. At the outdoor condenser I was losing power to turn on the unit. I checked the electrical components and found that the system had a pressure switch that was open and not allowing power to pass properly. I shared my finding with our client and she did authorize me to bypass the pressure switch to turn on and test the outdoor condenser unit. Once on I was able to test and measure the Freon pressures in the system. The pressures are extremely low and reflect a leak in the system. The compressor also has extremely high start amps, Almost past manufacture limit. This is caused by the system not having Freon and the extra demand from the compressor motor. It is only cooling with a 6° drop and the industry standard is 2
I found the capacitor for the master bedroom unit reading extremely out of range. I told the customer I could fix it today, I would have to install a turbo200. The customer declined. The customer signed off on a contactor, 45/7.5 capacitor, and a 30/3 capacitor. I installed the contactor at the time of service. We will need to pick up a 30/3 capacitor and return to install. I collected a 300.00 deposit on the work and my service fee of 45.00.
Arrived on site, customer stated ac was putting out warm air and not cooling the upstairs. Upon initial inspection, it was noticed there was rust in the emergency drain pan. Indicating that there is or was water not draining properly. It was found that the refrigerant pressures were very low. Suspected coil leak. Found leak in evaporator coil on the back side. Recommended coil replacement to restore systems cooling functionality. Customer decided to go forward with the repair. Deposit collected, will pick up coil today and schedule return date to complete repair. Est time for repair is Tuesday -Wednesday.
Performed single system cooling maintenance. I checked amps, filter, electrical, drains, cleanliness, temperature differential, refrigerant temperature, and washed the outdoor unit. The system is performing within manufacture specifications. To prepare the drain for cooling season, it is advised to perform a drain treatment. This is an attempt to prevent clogging from occurring. Customer said that her allergies have been bothering her lately and that the filter probably just needs to be changed. Upon observation, it was determined that the filter has minimal build up. I replaced the filter. I offered to upgrade the filtration and an air cleaning device (air scrubber).
Previous visit we found the #2 system (downstairs) frozen,,, we were not able to finish the spring maintenance ,, we were not sure if this was caused by the extremely dirty return filter we found or low on refrigerant,, today we checked refrigerant pressures, measured temperature differential in cooling mode and unit was working properly. We will send estimates for recommendations ( for downstairs/ upstairs)
Performed a 3 system spring maintenance ( gas). Tasks performed. 1. Visually inspected condenser coil for debris/ dirty. 2. Inspected condenser fan motors. 3. Inspected condenser fan blades. 4. Inspected/ cleaned wiring connections. 5. Tested compressor/ condenser fan motor capacitor. 6. Checked refrigerant pressure,,, downstairs unit is frozen ,,we need to come back and check again, issue might be caused by extremely dirty filter or low on refrigerant. 7. Checked compressors amp draw. 8. Checked condenser fan motors amp draw. 9. Inspected / replaced return filters,,, all 3 systems had extremely dirty filter . 10. Inspected return plenums for debris/ dirty,,,upstairs/ downstairs units are very dusty, highly recommend a duct cleaning. 11. Inspected evaporator coils. 12. Inspected blower motor/ blower wheels,,, downstairs/ upstairs are very dusty, highly recommend a blower cleaning. 13. Checked blower amp draw. 14. Measured temperature differential ,, temperature differential on the ups
Performed 2 system cooling maintenance. I checked amps, capacitors, filter, cleanliness, electrical, drains, temperature difference, refrigerant temperature, and safeties. The systems are cooling good, I did notice some issues. The main unit’s contactor is burning up. It has huge burn spots and the ohm value tested out of typical range. The 45/7.5 capacitor tested bad as well. It is reading 40/7. It is recommended both be replace to ensure proper function through the summer. The other unit’s capacitor is reading out of range. It is rated for 30/3 and is reading 26/.06. With these numbers, it is highly likely of a failure occurring soon. The blower motor has build up present. This adds stress to the blower motor and can result in premature failure.

