Adon Complete Air Conditioning and Heating provides HVAC services in Richardson, TX, running calls throughout Dallas and Collin County from our home base in Anna. Richardson sits right along the border of both counties, and we serve the full city – from the older ranch-style homes near downtown and the University of Texas at Dallas area to the commercial properties along the Telecom Corridor on US-75. Whether your AC goes out in the summer heat or your furnace needs service before a cold front moves through, we’re a straightforward call away.
Richardson’s housing stock skews older than many of the cities we serve, with a lot of homes built in the 1960s, 70s, and 80s that are on their second or third HVAC system. We know these homes well – older ductwork, non-standard configurations, systems that have been patched over the years. We service all makes and models, we’re a Trane Comfort Specialist and Mitsubishi-authorized dealer, and we offer 24/7 emergency service throughout Richardson and the surrounding area.
HVAC Services We Offer in Richardson, TX
AC Repair: Same-day AC repair available throughout Richardson and the surrounding Dallas-Collin County area. We diagnose and repair all makes and models, and most calls are resolved in a single visit. When your air conditioning fails during a Texas summer, we treat it as the emergency it is.
AC Installation and Replacement: Richardson’s older homes are prime candidates for system replacement – an aging unit in a 1970s home working against original ductwork is costing you more every month than a properly sized new system would. We do a full load calculation, size the system correctly, and install it to manufacturer specs. All new installations come with up to a 10-year labor warranty.
Heating Repair and Installation: We service gas furnaces, heat pumps, and electric systems throughout Richardson. Older furnaces in Richardson’s established neighborhoods are one of the more common service calls we get – aging heat exchangers, worn igniters, and cracked flue pipes are all things we catch and repair before they become bigger problems.
HVAC Maintenance: Our Adon Care Club plan is $12 a month and covers two seasonal tune-ups, priority scheduling, repair discounts, and 24/7 emergency access. For Richardson homeowners with older systems, regular maintenance is the most cost-effective way to extend equipment life and catch problems early.
Ductless Mini-Split Systems: Older Richardson homes with additions, converted garages, or rooms that were never wired into the main duct system are good candidates for ductless mini-splits. We install single and multi-zone systems and they’re far more efficient than window units for spaces that need year-round comfort.
Heat Pumps: Heat pumps handle both heating and cooling from one system, and in Richardson’s climate – where winters are cold but rarely brutal – they’re a practical, efficient option. We install and service heat pumps throughout Richardson and can help you decide if one makes sense for your home.
Indoor Air Quality: Older Richardson homes can struggle with dust, allergens, and humidity issues that newer construction handles with tighter building envelopes. We offer air filtration systems, UV air purifiers, humidifiers, dehumidifiers, and a free “What Are You Breathing?” screening for Richardson area homeowners.
Duct Cleaning and Duct Repair: In a city with as much older housing stock as Richardson, ductwork is one of the first places we look when a system isn’t performing. Aging ducts leak conditioned air into attics and crawlspaces, drive up energy bills, and create uneven temperatures room to room. We inspect, clean, and seal ductwork throughout Richardson.
Why Richardson Homeowners Choose Adon Complete
- We know older homes. A significant portion of Richardson’s housing stock was built decades ago, and we’re experienced with the ductwork, equipment, and configurations those homes typically have.
- Owner Jesse Villarreal has over 27 years of HVAC experience – when you call Adon Complete, you’re calling a local company where the owner’s reputation is on every job.
- We’re a Trane Comfort Specialist and Mitsubishi-authorized dealer, which means factory-trained installation and the full manufacturer warranty on every system we install.
- Same-day and 24/7 emergency service available throughout Richardson and Dallas County.
- The Adon Care Club is $12 a month – two tune-ups, priority scheduling, repair discounts, and no diagnostic fees year-round.
Neighborhoods and Areas We Serve in Richardson, TX
We provide HVAC services throughout Richardson, including the neighborhoods near downtown Richardson, the UTD campus area, Canyon Creek, Breckinridge Park, and the commercial corridors along US-75 (Central Expressway) and Campbell Road. We also serve Richardson’s neighboring cities including Plano, Garland, Allen, and McKinney.
Richardson, TX HVAC FAQ
How much does AC repair cost in Richardson, TX?
Most AC repairs in Richardson run between $150 and $600 depending on the type of repair. Simple fixes like a capacitor replacement or refrigerant recharge are on the lower end. More involved repairs like a blower motor or evaporator coil cost more. We give you a clear estimate before any work begins – call (903) 482-4900 to schedule a diagnostic visit.
Do you offer emergency HVAC service in Richardson?
Yes. We offer 24/7 emergency heating and air conditioning service throughout Richardson and the surrounding area. When you call after hours you reach a real person who can get a technician to your home fast.
My Richardson home is older and the AC can’t keep up. Is it worth repairing or should I replace it?
For older homes in Richardson, we look at a few things: the age of the system, the cost of the repair versus a replacement, and whether the existing ductwork is up to handling a new system efficiently. If a system is 15-plus years old and needs a major repair, replacement usually makes more sense. We give free estimates on replacements and honest second opinions on repair-versus-replace decisions.
What HVAC brands do you service in Richardson?
We service all makes and models including Trane, Lennox, Carrier, Daikin, Mitsubishi, Goodman, Rheem, and more. As a Trane Comfort Specialist and Mitsubishi-authorized dealer we have factory-trained expertise on those brands, but we don’t turn down a job because of what brand is on the equipment.
Do you handle commercial HVAC in Richardson?
Yes. Richardson’s Telecom Corridor and business parks are home to a lot of commercial office space, and we handle commercial HVAC service throughout the area. We work with offices, retail spaces, and light commercial properties, and maintenance agreements are available for businesses that want scheduled service and priority response.
Schedule HVAC Service in Richardson, TX Today
Whether you need same-day AC repair, a replacement on an aging system, or want to get on a maintenance plan, Adon Complete Air Conditioning and Heating is ready to help. Call us at (903) 482-4900 or click below to schedule. We also serve the surrounding communities of Plano, Garland, Allen, McKinney, and Wylie.
Recent Jobs and Reviews in Richardson, TX
Richardson, TX at a glance
Adon Complete Air Conditioning and Heating has completed 10 jobs in Richardson, TX between July 2025 and September 2025.
The most recent job was on September 22, 2025.
Adon Complete Air Conditioning and Heating has completed 28 jobs in Richardson, TX in the last 12 months. The first job there was in May 2020.
Job Locations
Arrived on site, homeowner stated all was well with system operation to her knowledge. I asked if she had addressed the plumbing issues from the last time I was here and the homeowner stated she had the vent pipe replaced, and then the clog removed. Started inside at t-stat (Honeywell original) turned system down to check over unit. System is level all wiring is good no error codes. Getting over 20 degree temp split. Drain line is draining well. Added a small amount of insulation to the p-trap where I noticed a little condensation. Plenum and filter are very dirty recommend duct cleaning. Outside unit is level all electrical components are good and tight. Start and run amps are within manufacturer specifications. Both indoor and outdoor fan motor are testing within manufacturer specs. All components are operating as designed. Pressures were within manufacturer specifications. Tested gas heat components and heating itself and found no issues. Unit in good working order upon departure.
Arrived on site for heating maintenance. Reviewed plenum installation per homeowner request and did not find any air leaks or condensation on the plenum. I did secure some of the wire mesh in the attic better with screws. Tested inducer motor start and run amps and found them to be within manufacturer specification as well as the capacitor. Tested pressure sensor to in sure proper function. Cleaned flame sensor of carbon build up to ensure it continues to work properly. Igniter is working without issue. Gas valve is allowing proper gas flow. Unit in good working upon departure.
We replaced the planum, connected all the ducts, and sealed everything.
After inspecting your HVAC system, I strongly recommend replacing the current 3-ton unit. We are performing a load calculation for the home. Given that this is an Airbnb with higher and more variable occupancy, a 3.5-ton system is likely a better fit to maintain comfort and reliability. Condensate Drain Line Concerns • You mentioned ongoing issues with the drain lines. • Our install team will flush and attempt to clear the existing condensate drain lines during installation. • If we cannot clean them sufficiently to restore proper drainage, I recommend installing a condensate drain pump to ensure reliable condensate removal. • Please note: a condensate pump is not included in the equipment estimate and would be a separate line item if needed. Scope Clarification • This proposal covers equipment replacement and standard installation. • Ductwork modifications are not included in this estimate. If duct changes are required after the load calculation or during installation, we’ll p
Cleaned ducts and cleaned any dust we left.
Estimate on a duct cleaning. Upon arrival customer stated that she’s selling the house and has a showing this weekend. Customer is wanting her ductwork cleaned to remove any odor in the house that might be unpleasant for a buyer. During my inspection I checked the ductwork and found them to be dirty, I showed my pictures to the customer and she agreed that they could use a cleaning. We will perform level duct cleaning on a single system home this Wednesday August 27th, we will arrive between 8am-9am. I also informed the customer about our air purification system to help purify the air and help remove odors but she isn’t interested at this time and only wants to do the duct cleaning for now. Customer is paying with a check and paid a $250 non-refundable deposit today via check.
Arrived on site, and found drain line not draining properly. Blew out drain line with nitrogen and line would drain initially. However, I would receive back pressure shorty there after stopping the line from draining. Adjusted pitch of drain line to ensure that was not the issue, and had no different results. Upon tracing the drain line, I found water leaking out of the cast iron vent pipe that the drain line was tied into. Advised homeowner that unit may not work properly until this issue is addressed and that a plumber would need to address this issue. I advised the homeowner that we could run another drain line draining outside into an irrigation box, however I recommended addressing the larger issue with the vent pipe. Unit running upon departure, and drain line intermittently draining.
1. Visually inspected condenser coil for debris/ dirty. 2. Inspected condenser fan motor. 3. Inspected condenser fan blades. 4. Inspected/ cleaned wiring connections. 5. Tested compressor/ condenser fan motor capacitor. 6. Checked compressor amp draw. 7. Checked condenser fan motor amp draw. 8. Inspected / replaced return filter. 9. Inspected return plenum for debris/ dirty. 10. Inspected evaporator coil. 11. Inspected blower motor/ blower wheel. 12. Checked blower amp draw. 13. Measured temperature differential from supply to return. 20 degrees measured. 14. Inspected drain lines and treated to prevent blockages 15. Rinsed condenser unit to promote heat exchange 16. Replaced and dated filters Units in good working order upon departure.
Silver 14 Air Conditioner SEER2 GAS : American Standard GAS Complete System: (NEW) 2025 SEER2 (System Change Out Only) Outside unit: Furnace: Evaporator Coil: Thermostat: Honeywell T6 Capacity 5 Ton Climatuff: 1 Stage - Speed Air Conditioner ADON CARE CLUB MAINTENANCE PLAN 1 Year Maintenance (Spring / Fall: Safety Checks) Protects your manufacturer warranty Prolongs the life of your cooling and heating system American Standard Manufacture Extended Warranty 10 - Year Compressor Warranty 10 - Year Parts Warranty **** Labor Warranty **** 1Year Labor Warranty: JB Warranty & Associates Equipment Registered by Adon CPS **** Quality Control **** Quality Control follow up visit by Technician What's Included Material/ Parts Breaker Disconnect Box Electrical Whip Cement Condenser Pad Up to 4 bags Dirt for leveling Secondary Auxiliary Drain Pan Drain Line installation - Up to 6 Ft SS1 Emergency shut off Float Switch Quick Blast Valve for Drain maintenance Foil Tape PVC Fittings Super
Upon arrival, I found the compressor was off on thermal overload. I cooled the compressor down and checked my refrigerant pressures. The system is low on 410a refrigerant. The system is a 2012 gas system. I presented options to the customer to address the issue. I offered filling it up with refrigerant, filling it up with leak seal, and system replacement. The customer elected to proceed with system replacement. The customer chose the 14 seer2 American standard 5 ton gas complete. It is scheduled to be installed on Thursday. 7/31/25. I collected half as down payment for the install.

