Whitesboro TX Heating And Air Conditioning

HVAC SERVICE DIAGNOSTIC REPORT SYSTEM EVALUATION Arrived on site and performed an operational inspection of the existing HVAC system. Indoor Equipment: * Verified indoor blower is operational. * Indoor unit is moving air through the duct system. * System is currently unable to provide proper cooling due to refrigerant-related conditions at the outdoor equipment. Outdoor Equipment: * Inspected outdoor condensing unit. * Determined system is completely out of refrigerant. * Existing HVAC equipment is approximately 19 years old. * Due to the age of the equipment and current refrigerant condition, significant repairs may not be economically practical compared with system replacement. COMFORT & DUCTWORK EVALUATION Discussed existing comfort concerns with the customer, including hot spots on the south side of the home. The home has a large attic area that may provide an opportunity to relocate/install the replacement indoor HVAC equipment in the attic. This would allow us to evalu

Arrive for one system AC maintenance. Customer just replaced filter, it is still good. Checked operation of drain lines, they are clear. Treated primary drain line with drain solution. Measured amp draw on blower motor. Measure temperature drop across system, 72° at return and 53° at supply. Next, went outside to condenser. Measured Amro on compressor and condenser fan motor. Check capacitor and contactor, they are both within acceptable tolerance. System has hard start kit installed. Clean condenser coil using water. System is cooling at this time.

NA

Invoice for the 10 year extended warranty.

HVAC ONLY 240V SURGE PROTECTOR INTERMATIC AG3000 OR EQUAL SURGE PROTECTORS PROTECT SYSTEMS FROM SIGNIFICANT POWER FLUCTUATIONS. 521 ELECTRONIC HARD START 189-227 UF 170-277V 1 HP AND UP HARD STARTS ARE USED TO GIVE COMPRESSORS A HIGHER STARTING BOOST OF CURRENT WHEN NEEDED TO START.

Preformed heating maintenance on a single gas Trane system. I tested all electrical components and safeties on the furnace. All tested within manufacturer specifications. I checked the filter for cleanliness. The client had recently changed the filter. Temperature being supplied to the home was at 111 degrees and return air was at 71. I proceeded to check the outside unit where I found that recent repairs of a Contactor and capacitor were changed, I tested he start amps to insure the compressor was starting up good, I found that the compressor is testing over 100 amps manufacturer rating for start up is 124 amps, that could be a possible reason why the Contactor and capacitor failed within a year. I also noticed the system did not have any type of surge protection. Surge protection can help prevent damage to the ac unit from lightning strikes, brown/black outs and just random power surges throughout the year. Unit was heating upon departure.

Upon arrival, I turned the unit on to cool. The system powered on with no issues. I began thoroughly examining the equipment. Customer stated that the indoor unit was blowing air that wasn’t cold. I checked the electrical in the outdoor unit. The capacitor was right at the bottom side of recommended rating 42.5/45. I removed the 24v common off of the contactor. The contactor ohmed at 19. When I went to plug in the 24 common wire, the contactor began emitting an awful buzzing noise. The last time I heard that noise, it shorted out the thermostat and contactor. I quickly removed the wire and reached out to Jacob for approval to replace the contactor and capacitor under parts/labor warranty. Customer is up and cooling with no further issues. Suggested adding surge protection to the equipment.

Performed single system cooling maintenance. I checked amps, capacitors, filter, electrical, drains, refrigerant, temperature split, and cleanliness. The system is performing within manufacture specifications. I provided pricing for membership, a surge protector, and a bottle of our drain treatment. Customer declined offered services at this time.

Performed single system heating maintenance on a 2024 furnace that we installed. I checked amps, filter, electrical, cleanliness, and safeties. The system is performing to manufacture specifications. Due to the customer not having a labor warranty, I offered it since it is still within the 18 months of installation.

Performed single system heating maintenance. Checked amps, filter, cleanliness, electrical, and safeties. System is performing to manufacture specifications. Customer mentioned humidity being a little uncomfortable. I adjusted the dehumidification overcool another degree up.

Indoor air quality Replaced the UV light bulb to ensure healthy clean air for the holidays. Adon, your comfort specialists.

Fall maintenance for the Lovell family, Whitesboro

6 system winter inspection

Two complete change outs downstairs, coil and condenser for other three systems. Checked 6th system (GYM), VERY low on charge. Could not find leak at this time. Complementary 410A refrigerant charge of unit.

George Straw

George Straw

Cooling AC system repair Replace outdoor coil temp sensor and clean effects failure.

Perform service agreement for 6 systems and clean /clean effects

Spring tune up for one system. Try to sell coil cleaning and Reme Halo.

Spring maintenance for the Lovell family, Whitesboro